Oh and if your planning on new bushings don’t bother with the MOOG crap I went through 3 sets and all were junk just save yourself some time and aggravation and get the proforged ones.
I already put new bushings in mine. I purchased all the needed parts for restoration when I bough the car over 10 years ago and then the project sat in my shop until recently when I started the restoration. Being that old all of the moog part are made in the USA. Hopefully they will be good. So far everything fits and installs fine.
I am doing battle with the Prothane sway bar bashings but I should conquer that today after cutting the cages open. What a PIA these have been. Maybe the rubber can be pushed into the cages but the urethane can't be without cutting them. I cut one side and bent them open. Bending them closed is also a PIA so I would recommend cutting both sides. YMMV.