New 408 build finally started

pittsburghracer said

Appreciate it but I’m pretty sure they would be even less offset. I’ll take a break from it and rethink things. My other set of heads went 9.74 on a worn out block in Pa during the summer. They just need me to touch up the valve job and check the springs out.

Click to expand...

Been a bit since I’ve seen the HS stuff but IIRC they use a different diameter shaft than OE chrysler don’t they???

If it’s the same you can use a W2 rocker next to the HS exhaust rockers you have, although the geometry is different between the HS and the ductile rockers.

Damn...can’t think of a quick and dirty way to get this done. I’d love to see how this turns out.