Time for 727 rebuild.
I was able to split the governor support and remove it from shaft. Unfortunately the shaft had some deep scratches. So I picked up a new support, used output shaft, reverse drum and band locally.
I started to check pieces and the governor support will not go in case. I checked back with shop and they said it was right support. I checked with another shop and he brought out some used one and they were the same.
So what gives. Do I have a bad case, wrong support? Do I need to sand off some to make fit? How tight of fit is it? I can't check the old one because I split it.
Any one else run into this? Anyone have a support or case they can measure?
I was able to split the governor support and remove it from shaft. Unfortunately the shaft had some deep scratches. So I picked up a new support, used output shaft, reverse drum and band locally.
I started to check pieces and the governor support will not go in case. I checked back with shop and they said it was right support. I checked with another shop and he brought out some used one and they were the same.
So what gives. Do I have a bad case, wrong support? Do I need to sand off some to make fit? How tight of fit is it? I can't check the old one because I split it.
Any one else run into this? Anyone have a support or case they can measure?
