Stop in for a cup of coffee
It was an uphill battle, but i don’t feel defeated. Driveshaft was .010 too small to accept u-joint that fit rear pinion yoke. So i used a king pin reamer to open it up a tad. And was .025 too wide,give it a squeeze in vice. Too redneck, going to build a shaft that will work. But good enough for now..Dad always said, “it’s not a piano”.
It was an uphill battle, but i don’t feel defeated. Driveshaft was .010 too small to accept u-joint that fit rear pinion yoke. So i used a king pin reamer to open it up a tad. And was .025 too wide,give it a squeeze in vice. Too redneck, going to build a shaft that will work. But good enough for now..Dad always said, “it’s not a piano”.