Rally dash redo
Ok PLAN B.
I decided to work with a 67 harness as opposed to swapping a 68 over. This hopefully means less changes. There was more than I cared for in the initial swap. I will thoroughly check this one out thoroughly(yellow door switch wires need replacing, headlight dimmer switch connector and wires, heater switch wires) need close inspection.
t doesnt appear to be too many changed/repairs. Just some stiff wires really. Orig ammeter wires intact.
Thanks to
@blewbyu it's a nice piece!
With proper 67 schematics and harness this will make it easier(hopefully).
All connectors except turn signal and fuse box are labelled and removed. Verified before removal with factory schematics.
Peeled back wrap where need be for removing yellow wire. Not sure how long to make new one?? Add 2 feet to each end?
Also I ordered a 36 piece connector removal tool set. Off ebay.. .from China...:BangHead:
Another question...turn signal connector and wires. Initially they look good and clean....should I remove wires anyway from connector ?