Rally dash redo

Nice, the Iwiss set I got is ratcheting and nice but the interchangeable dies(5 of them) dont crimp the common 14-16 gauge wire very well. Dies weren't machined properly.
Here are pics of those other terminal ends. They go to heater blower switch.(pics 1/2 ) 3rd pic is of normal chrysler terminals. They are on opposite end of heater wires that lead to blower motor resistor. 5th/6th pics are of the plastic housings. Very similar.
4th pic is of red wire connected to purple wire...not sure what that's about.
Tomorrow lol
If its just discolored maybe just a stain not heat?

I haven't removed a door jamb switch in years. Someone here will know.
I remembered you got terminals from PICO but figured might be some things they didn't have.

On the female terminals I got pretty good using the compound crimper. It's Astro brand. Had to experiment a bit to figure out which jaws match which terminal sizes best. It does both the wire and insulation crimps at the same time. On the male terminals the jaw is too wide. I was thinking of grinding it down but didn't. Ended up buying the replica Packard crimpers knowing I had more stuff ahead.

View attachment 1715507445
Can't get in tight or awkward spaces with it but otherwise not bad.
I seperately bought jaws for ignition and CAT5 wiring
View attachment 1715507446

20200413_221902.jpg

20200413_221922.jpg

20200413_221945.jpg

20200413_223128.jpg

20200413_225827.jpg

20200413_225855.jpg