Engine install

I know Its a little early for this but like planning ahead. I just dropped off my engine off at the machinist so I'm trying to get a game plan for installing it. Here is my plan since I dont have a garage or any concrete to move the engine hoist I'm gonna get the engine lifted up and push the car under the engine. Iv done it before in the past and it worked. As far as the engine bay itself goes I want to leave out anything I can to make room that i can install after the engine is in. I'm gonna have my brake lines run but leave the master cylinder out. Have my steering gearbox installed but leave the steering column out. I'm gonna have the control arms and everything connected obviously so I can roll it. I know I have to leave the tie rods out for the headers but should I leave the torsion bars out too or put them in? Anything I'm forgetting? Any tips and tricks are greatly appreciated!