W2 heads I think they are ready

12swinger said

So they measure from the bottom of the rocker to the pushrod cup .280” under .300”
So I’m assuming the 9/32 is probably to the end of the ball to rocker? So to short?
I get it Crane isn’t very clear on the 2-3 thread crap which is what I measured for.

Click to expand...

Yes, end of the ball to the rocker should be the 9/32 measurement IF you have the oil hole where Chrysler put it.

I can’t remember seeing any Crane made MP rockers with the lowered hole, but the first set of Crane’s I ordered had it and I sent them back and got the rockers with the Chrylser oil hole location in them.