Removal is piece of cake if you have a welder! Install is a pita if you don’t have the correct adapters. Just looking for what you guys do to install bushing and pin together. Again this for lower control arm.
Didn't you get to figure it out from reading the "sticky" or looking at the pictures, that i helped you out with?
Nothing hard, difficult, at all in the installation of the bushing and the shaft together.
All you need is a piece of water pipe, fence pipe, the same diameter as the outer diameter of the bushing.
That's the "factory" tool.
Easy, peasy.
Don't have a piece of pipe, go buy a length, at the local hardware store, or plumbing shop.