Plastic interior pieces in early Barracudas
got the temporary molds laid up and hoping to get a test pull, before making a permanent mold and when I do the convertible outer rear panel side trim pieces I had to block it a bunch to straighten up the sides from heat damage and a little bit more to do. I do have a question though on the rear section that always breaks how far in is the hole shown in the bottom picture? I tried scaling it up a bit to match my part and came up with 3/4" inboard from the edge, does that sound/look correct?
n 
got the temporary molds laid up and hoping to get a test pull, before making a permanent mold and when I do the convertible outer rear panel side trim pieces I had to block it a bunch to straighten up the sides from heat damage and a little bit more to do. I do have a question though on the rear section that always breaks how far in is the hole shown in the bottom picture? I tried scaling it up a bit to match my part and came up with 3/4" inboard from the edge, does that sound/look correct?
