Bump steer question
When I checked mine, I needed to remove spacers to make this 100% theorically perfect. But mine was allready at the lowest setting.
Luckily, my numbers were very good. The circle track and road course chassis builder told me just to leave it.
Edit: Just an FYI, 0.082" is only a little over 1/16" toe out at 3" compression. And 0.114" is only a little under 1/8" toe in at 3" rebound/extension.
I run probably close to 4 TIMES the spring rate a drag car does with my 1.14" T-bar. So I might only see those 3" numbers in a few corners on a road course
When I checked mine, I needed to remove spacers to make this 100% theorically perfect. But mine was allready at the lowest setting.
Luckily, my numbers were very good. The circle track and road course chassis builder told me just to leave it.
Edit: Just an FYI, 0.082" is only a little over 1/16" toe out at 3" compression. And 0.114" is only a little under 1/8" toe in at 3" rebound/extension.
I run probably close to 4 TIMES the spring rate a drag car does with my 1.14" T-bar. So I might only see those 3" numbers in a few corners on a road course