1968 Barracuda Notch - Plano, TX
Picked up the condenser, compressor, and glove box this past week.
Saturday was raining, set up the tarp, used it again today for the sun!
Mockup / test fit top drivers side bracket yesterday
Final design for upper drivers side done today. Mockup needed washers to space it out and the mounting hole is at an angle. Warmed up some steel with a torch, put a little offset in it and a twist.
Mockup / test fit top passenger side bracket yesterday
And today, added the offset and the twist.
Made a first pass guesstimate on the power steering bracket, cut a piece of MDF and set it on some all thread.
Needs to come up an inch. After I get it where I want I will make the rear bracket, the spacers and everything else it needs. There will also be an idler pulley so the belt coming across from the passenger side can come across low and wrap around about 1/2 the power steering pulley. Final brackets will be steel plate or aluminum, haven't decided yet.
Picked up the condenser, compressor, and glove box this past week.
Saturday was raining, set up the tarp, used it again today for the sun!
Mockup / test fit top drivers side bracket yesterday
Final design for upper drivers side done today. Mockup needed washers to space it out and the mounting hole is at an angle. Warmed up some steel with a torch, put a little offset in it and a twist.
Mockup / test fit top passenger side bracket yesterday
And today, added the offset and the twist.
Made a first pass guesstimate on the power steering bracket, cut a piece of MDF and set it on some all thread.
Needs to come up an inch. After I get it where I want I will make the rear bracket, the spacers and everything else it needs. There will also be an idler pulley so the belt coming across from the passenger side can come across low and wrap around about 1/2 the power steering pulley. Final brackets will be steel plate or aluminum, haven't decided yet.