Throw out bearing question

When the release bearing comes off, is it that one spring is on the fork deeper and one is off, or are both off?
Can you back off on the clutch release adjust and still disengage the plate?
Is your driver side engine and the trans mount good?
Update: I put bearing back on fork both clips look stretched out. Bearing is centered correctly moves free and touches all 3 fingers equally the pivot is correct. Had a helper push clutch in and found zbar was moving up and down slightly. Removed zbar the outer stud only had one bushing half in it. No clue how it came out, it was in there when I put zbar in.but the seal was torn and one piece missing. I’m ordering a new bearing to be safe.