little update
I think I'm 80% done here
I got the pipes cut down and the mufflers moved up to where I want them
of course, the second one i cut before the bend, so i got to weld that back on and cut it again
when the tips come in on friday I'll do the final alignment and install the hangers
I think I might be able to pull one of the front spring perch bolts out on each side to bolt the hangers down with
the pic with the pipe sticking out the side is just a scrap piece to show where the tip will end
as you can tell I also had to adjust both 45s to suit me a bit better
didnt go to bad considering I was using just a little fluxcore welder
View attachment 1715498720
View attachment 1715498721
View attachment 1715498722
View attachment 1715498723
View attachment 1715498724
View attachment 1715498725