ProComp/Speedmaster aluminum heads

Well I was able to get a couple of hours in the garage and look at how the rockers are going to look... Putting the passenger side rockers on and putting in the 2 intake pushrod and the 8 exhaust of course left with their previous adjustments from the factory heads they were just a little bit tight and not having the .019 lash they should have had had everything been exactly the same... I readjusted to .019... The roller tip seemed a little in board and rolling out to just about the center which was not a really long sweep maybe 30-40 thousandths...
When I got my roller rockers from Hughes they came with two sizes of shims.. I tightened the rockers down without the push rods with just the largest shim and it didn't seem to make a tremendous amount of difference but I did move them forward. Then I got a little carried away and put both the small and large shim in and put the two pushrods back in and ran them through the sweep.. the first thing I noticed was the adjusters had to come out much further than I was really comfortable with. It seemed to make the sweep start from the center and work its way out from there to 3/4 of the way out across the top of the valve tip.. I think tomorrow I'm going to just start with one shim and lock it all down. I've got those .080 lash caps in my Summit shopping cart and I might send for those as well so I don't have a lot of adjuster sticking out which I did not like...