Red Headed Stepchild-75 Swinger LSX Swap
Well i started to look into the fuel pump controller tonight and thought I was going to be having an issue with pulling the the 12vdc signal off the tach output that is required by the controller. So I stopped until I got more clarification from holley, aeromotive and some more people who have used the exact controller etc.. that im running.. so ill get started on that tomorrow.
After that I got started on the a2w plumbing. Had to run down to home depot. Had to pick up 20 feet of the braided hose for the pump to intercooler and to the ice box.
Got the fittings installed in the ice box and the intercooler. Fed the hoses to the intercooler and then began routing them back. Made it as far as the trans support before those two 10 foot lines ran out. So ill have to get some more tomorrow.
After that i broke put the seam sealer and took care of some finishing touches around the pan in the trunk and the gaps in the firewall where the cage came through and got those cleaned up and sealed. Not much for pictures today. Promise more tomorrow. Here you can see the hoses coming out and up and then running down the driver side. Just ziptied for now.
Well i started to look into the fuel pump controller tonight and thought I was going to be having an issue with pulling the the 12vdc signal off the tach output that is required by the controller. So I stopped until I got more clarification from holley, aeromotive and some more people who have used the exact controller etc.. that im running.. so ill get started on that tomorrow.
After that I got started on the a2w plumbing. Had to run down to home depot. Had to pick up 20 feet of the braided hose for the pump to intercooler and to the ice box.
Got the fittings installed in the ice box and the intercooler. Fed the hoses to the intercooler and then began routing them back. Made it as far as the trans support before those two 10 foot lines ran out. So ill have to get some more tomorrow.
After that i broke put the seam sealer and took care of some finishing touches around the pan in the trunk and the gaps in the firewall where the cage came through and got those cleaned up and sealed. Not much for pictures today. Promise more tomorrow. Here you can see the hoses coming out and up and then running down the driver side. Just ziptied for now.