Red Headed Stepchild-75 Swinger LSX Swap
Well i have been getting more done despite the wait. The vent line and rollover valve are mounted now, I finished wiring up the trans brake(minus the 3 wires from the holley protector that will be here tomorrow).
Had to swap the input wires around on the holley setup because one was frequency(trans temp sensor) and one was 12v hot input(trans brake input to trigger the 2 step and launch control). But i have it right now.
Finished tightening up the passenger seat and its good to go now. Adjusted the front and moved it up a little bit. Felt like it was too low before, and give better clearance on the dowpipe/tires.
Fuel pump shipped out today from aeromotive, so with any luck it'll be here by Saturday in time to install this weekend. Then maybe we can fire it up and drive it around this weekend as well.
Oh and here are some outsidey pics I took today as well.
Well i have been getting more done despite the wait. The vent line and rollover valve are mounted now, I finished wiring up the trans brake(minus the 3 wires from the holley protector that will be here tomorrow).
Had to swap the input wires around on the holley setup because one was frequency(trans temp sensor) and one was 12v hot input(trans brake input to trigger the 2 step and launch control). But i have it right now.
Finished tightening up the passenger seat and its good to go now. Adjusted the front and moved it up a little bit. Felt like it was too low before, and give better clearance on the dowpipe/tires.
Fuel pump shipped out today from aeromotive, so with any luck it'll be here by Saturday in time to install this weekend. Then maybe we can fire it up and drive it around this weekend as well.
Oh and here are some outsidey pics I took today as well.