1964 - 1966 Barracuda starter removal and installation advice

I recently put a mini-starter in my 1965 Chrysler w/ 383. I had earlier put one in my 1965 Dart w/ 273 and recalled no problem. I had a few around, some from junkyard 1980's Dodge trucks w/ Magnum V-8 and some rebuilt off ebay. It has been a month, but I recall at least one starter wouldn't quite bolt-up since it hit the block from a stand-off on the electrical connectors, so watch close. I recall I removed the standoff so it fit, though might have switched to another starter. A bit scary that the big BAT+ terminal sits only 1/8" from the block, so if a nut fell down between them - welding torch!. I don't remember that issue on the 273. I wouldn't fool with the OE starter on either V-8. I recall that getting it out on my 273 required getting the Pitman arm and linkage in just the right place, and the beast is heavy. I can use up my OE starters in my slant engine where a starter swap is real easy. BTW, the Magnum V-6 starters are the same. You find those engines in the earliest Dakotas and vans. The Jeep GC uses the Magnum V-8 but has a different starter.