noob valve spring question
Hi everyone, my first time doing valve springs. The engine is the rebuilt (by the previous owner) 318 that I was told is from an 80's Ramcharger. He used a Summit K6900 cam but left the stock springs. I thought that the bad cutting out when it hit about 4000 rpm was a fuel problem, since it still had a 2bbl on it, but after changing to a 4bbl I've now concluded it's valve float since I can duplicate it with the trans in Park by slowing increasing the throttle.
I ordered a set of TrickFlow TFS-16901-16 springs and the matching TFS-514000423 retainers from Summit. I've gotten as far as taking one spring off and noticed there's a shim under it. My first question is, do I reuse that shim with the new springs? I'm guessing no, but thought I should check.
Second question, which is the real problem... When I put the springs in my "cart", I also added the retainers that Summit said were required.
I just found out when struggling to get the keepers to fit that they are for use with 0.342" valve stems:
I measured the valve stem and it's 3/8". Does anyone know if the Comp Cams 740-16 retainers will work with the TrickFlow springs? The application tab says they cover a wider range of valve stem diameters:
COMP Cams Steel Valve Spring Retainers 740-16
I just tried calling Summit but they don't have weekend tech support, so hopefully some here can set me straight.
Hi everyone, my first time doing valve springs. The engine is the rebuilt (by the previous owner) 318 that I was told is from an 80's Ramcharger. He used a Summit K6900 cam but left the stock springs. I thought that the bad cutting out when it hit about 4000 rpm was a fuel problem, since it still had a 2bbl on it, but after changing to a 4bbl I've now concluded it's valve float since I can duplicate it with the trans in Park by slowing increasing the throttle.
I ordered a set of TrickFlow TFS-16901-16 springs and the matching TFS-514000423 retainers from Summit. I've gotten as far as taking one spring off and noticed there's a shim under it. My first question is, do I reuse that shim with the new springs? I'm guessing no, but thought I should check.
Second question, which is the real problem... When I put the springs in my "cart", I also added the retainers that Summit said were required.
I just found out when struggling to get the keepers to fit that they are for use with 0.342" valve stems:
I measured the valve stem and it's 3/8". Does anyone know if the Comp Cams 740-16 retainers will work with the TrickFlow springs? The application tab says they cover a wider range of valve stem diameters:
COMP Cams Steel Valve Spring Retainers 740-16
I just tried calling Summit but they don't have weekend tech support, so hopefully some here can set me straight.