Cheap plasma cutter any good?

I use a Cut60 plasma cutter from amazon or ebay. Dont recall.
Rated for 220/110

I hooked it up for 220v

I have cut alot of stuff with it.
I built a 1932 ford frame from 1/8 sheet metal. Has cut alot of scrap metal (washer dryers etc)
Also processed aluminum subframes to take the steel out.

I mainly bought it for auto body metal to build the model A.

I did not buy it for heavy metal work (anything over 1/4 inch). That's where the propane torch shines.

The only issue I had was the first gun shorted out. I bought a new gun with a longer lead. Tips are the next issue. I bought 1000 tips and cones and I am almost out. Just debating on whether to buy more tips or move on to a hypertherm. I do seem to blow thru alot of tips but I will likely buy more tips from ebay and keep going as I really do not have any more complaints.

For the price I think the cut 60 has outperformed my expectations.

I do drag the tip on the steel.