Red Headed Stepchild-75 Swinger LSX Swap
Sorry I waited so long been all kinds of busy.
1. The new steering wheel came in and basically looks killer and weighs almost nothing.
2. Jegs upset me by telling me the quick release would ship next day, then after I ordered it, it was backordered. Now it is supposed to ship this Thursday the 16th. Fingers crossed it does.
3. Found my issue with the idle and driving issue. The diaphragm on the fuel pressure regulator was cracked and wasn't holding pressure. Thus the garbage reading on the gauge before. New regulator installed. Issue resolved.
4. 5 bar sensor is installed/wired up and plumbed.
5. While waiting on parts I got started on my side mirror mounts. Got them smoothed out and on place. Definitely not something I've ever seen on a dart but I think the styling is spot on. These arent the final. They are going to be 3d printed by a buddy of mine so I know they're solid and one piece. But I think they look killer. Let me know what you guys think.
6. Got the Mickeys mounted, but then found out one had a flat spot. So they sent me another one that will be here tomorrow so I can get it redone this weekend.
7. She is scheduled for the alignment next Tuesday.
8. She is scheduled for the dyno August 12th and if everything goes well I hope to be starting test n tune the following weekend in NC at the Rock if they all tnt for that event.
Sorry I waited so long been all kinds of busy.
1. The new steering wheel came in and basically looks killer and weighs almost nothing.
2. Jegs upset me by telling me the quick release would ship next day, then after I ordered it, it was backordered. Now it is supposed to ship this Thursday the 16th. Fingers crossed it does.
3. Found my issue with the idle and driving issue. The diaphragm on the fuel pressure regulator was cracked and wasn't holding pressure. Thus the garbage reading on the gauge before. New regulator installed. Issue resolved.
4. 5 bar sensor is installed/wired up and plumbed.
5. While waiting on parts I got started on my side mirror mounts. Got them smoothed out and on place. Definitely not something I've ever seen on a dart but I think the styling is spot on. These arent the final. They are going to be 3d printed by a buddy of mine so I know they're solid and one piece. But I think they look killer. Let me know what you guys think.
6. Got the Mickeys mounted, but then found out one had a flat spot. So they sent me another one that will be here tomorrow so I can get it redone this weekend.
7. She is scheduled for the alignment next Tuesday.
8. She is scheduled for the dyno August 12th and if everything goes well I hope to be starting test n tune the following weekend in NC at the Rock if they all tnt for that event.