Trick Flow small block heads
I have a set of TF small block heads @B3RE right now. Mike says as far as the geometry is concerned they are good right out of the box and should not require any corrections. I am buying the valve train from him as well, and he may have some proprietary mods incorporated there.
I also have a big block E-body that have trick flows, and i used the Harland Sharp valve train per TF and the geometry correction was pretty substantial.. about 1/4 inch up and back.. My smith brothers push rods were just shy of 10", but the geometry is right on.
I have a set of TF small block heads @B3RE right now. Mike says as far as the geometry is concerned they are good right out of the box and should not require any corrections. I am buying the valve train from him as well, and he may have some proprietary mods incorporated there.
I also have a big block E-body that have trick flows, and i used the Harland Sharp valve train per TF and the geometry correction was pretty substantial.. about 1/4 inch up and back.. My smith brothers push rods were just shy of 10", but the geometry is right on.