Distributor Tester
In my "spare time" I am building a distributor tester. I based it on this post from the internet
Build Your Own Distributor Test Machine For Under $100
I have it all together except for the plug wires
The first distributor I will put on it has a Pertronix IgnitorI module.
My question is Can I short the plug wires to ground, or should I run them through an actual gapped plug. I don't want to harm the electronic module @Mattax @Dana67Dart
(not intentioally leaving out any other electrical gurus.)
(Pertronix coil so I don't need a ballast resistor.)
Thank you
In my "spare time" I am building a distributor tester. I based it on this post from the internet
Build Your Own Distributor Test Machine For Under $100
I have it all together except for the plug wires
The first distributor I will put on it has a Pertronix IgnitorI module.
My question is Can I short the plug wires to ground, or should I run them through an actual gapped plug. I don't want to harm the electronic module @Mattax @Dana67Dart
(not intentioally leaving out any other electrical gurus.)
(Pertronix coil so I don't need a ballast resistor.)
Thank you