AC guinea pig...
So I have a few afterthought notes here as there was things that I was curious about that I didn't quite learn till after I got the kit...
I'm sure there's plenty online but I wasn't quite sure exactly how all the hoses were routed by their sizes. At least I didn't have a picture of it to go by until I got the instructions. Like knowing the number 10 line was this big return line from the evaporator to the compressor and knowing the number eight line was the shorter line going from the compressor out to the condenser which has to be oriented so the number eight line is at the top. Then last the number 6 line that went from the condenser to the evaporator. And knowing I could put the dryer anywhere along that number 6 line that was convenient. And that it had to be oriented top up.. and a very important point that it had an inlet and an outlet...
And it was nice knowing after calling and asking that now even though it doesn't say it has a harness kit in it all kits now have a wiring harness with relay and it's pretty much marked for plug-and-play... Also even in my case with a custom build there was more than enough wire that I did not have to splice in any extra and it's all encased in a corrugated tubing for protection. As a matter of fact in one spot I had to kind of coil it up and zip tie it down as there was too much...
So I have a few afterthought notes here as there was things that I was curious about that I didn't quite learn till after I got the kit...
I'm sure there's plenty online but I wasn't quite sure exactly how all the hoses were routed by their sizes. At least I didn't have a picture of it to go by until I got the instructions. Like knowing the number 10 line was this big return line from the evaporator to the compressor and knowing the number eight line was the shorter line going from the compressor out to the condenser which has to be oriented so the number eight line is at the top. Then last the number 6 line that went from the condenser to the evaporator. And knowing I could put the dryer anywhere along that number 6 line that was convenient. And that it had to be oriented top up.. and a very important point that it had an inlet and an outlet...
And it was nice knowing after calling and asking that now even though it doesn't say it has a harness kit in it all kits now have a wiring harness with relay and it's pretty much marked for plug-and-play... Also even in my case with a custom build there was more than enough wire that I did not have to splice in any extra and it's all encased in a corrugated tubing for protection. As a matter of fact in one spot I had to kind of coil it up and zip tie it down as there was too much...
