Rally dash redo
The reason this one didn't lay flat and tight turned out to be adhesive of some sort.
After I ground down the epoxy and pushed the stake nubs out of their holes, the script was still hanging on.
The stuff was more like rubber cement and didn't cut easily. Ended up using the tip of an exacto to slowly tease it off the surfaces.
I don't know if this adhesive was a part of the reassembly process, or left over and earlier step in their process.
It doesn't look like rubber cement, just acts like it when I was removing it.
And..IT'S ALIVE! (sans glovebox door)
The reason this one didn't lay flat and tight turned out to be adhesive of some sort.
After I ground down the epoxy and pushed the stake nubs out of their holes, the script was still hanging on.
The stuff was more like rubber cement and didn't cut easily. Ended up using the tip of an exacto to slowly tease it off the surfaces.
I don't know if this adhesive was a part of the reassembly process, or left over and earlier step in their process.
It doesn't look like rubber cement, just acts like it when I was removing it.
And..IT'S ALIVE! (sans glovebox door)