1969 B7 Dart project
I used Feel Firms's stuff for all the suspension. Leaf springs with a 1 inch + 8 3/4 with 3:91 posi. Dr Diff rear disc and green stripe bearings.
rear tires are 255-60 15, MT ET's
Battery is mounted on right side of trunk I would run the wire a little different than I did. I would put a hole on the inside of the frame rail on the top of the hump, use a grommet, so it is ahead of the shocks then run it across the hump to the left rail, on the inside , up to the starter. I did it right at the battery on the outside of the rail, behind the rear tire. It is not a good place for a street car, gets dirty easy and hard to clean. I put a cuttoff switch in the ground wire with the lever in a boxed section under the car.
I used Feel Firms's stuff for all the suspension. Leaf springs with a 1 inch + 8 3/4 with 3:91 posi. Dr Diff rear disc and green stripe bearings.
rear tires are 255-60 15, MT ET's
Battery is mounted on right side of trunk I would run the wire a little different than I did. I would put a hole on the inside of the frame rail on the top of the hump, use a grommet, so it is ahead of the shocks then run it across the hump to the left rail, on the inside , up to the starter. I did it right at the battery on the outside of the rail, behind the rear tire. It is not a good place for a street car, gets dirty easy and hard to clean. I put a cuttoff switch in the ground wire with the lever in a boxed section under the car.