67/68/69 cuda dilemma
Got the primer done. Was going to spray the parts tuesday afternoon right after work, but 2 things happened. 1 the weather started to turn bad and was rainy the rest of the week, and the parts got some flash rust on them between monday and tuesday. I was a bit miffed, but packed it all in plastic bags and hoped for the best to try to keep moisture out. I blasted them again today and painted everything. We also made some steel angles to replace what appeared to be missing tabs to tie in the rear wheel houses at the rear ends of both rockers when I took everything apart initially.
I had a bunch of help today. I believe he looks pleased with himself for making that part. Passenger side rocker at the aft end looks waaay worse. I may be sectioning in a piece of the right rear rocker from that cadaver I'm cutting up. A bit of sanding on the drivers side wheel house. I welded in the angle and the upper forward spare tire jack mounting support to the RH outer wheel well using dimensions off the parts cuda back end. We will be sanding that one down and prepping that one for primer this week as well.
Got the primer done. Was going to spray the parts tuesday afternoon right after work, but 2 things happened. 1 the weather started to turn bad and was rainy the rest of the week, and the parts got some flash rust on them between monday and tuesday. I was a bit miffed, but packed it all in plastic bags and hoped for the best to try to keep moisture out. I blasted them again today and painted everything. We also made some steel angles to replace what appeared to be missing tabs to tie in the rear wheel houses at the rear ends of both rockers when I took everything apart initially.
I had a bunch of help today. I believe he looks pleased with himself for making that part. Passenger side rocker at the aft end looks waaay worse. I may be sectioning in a piece of the right rear rocker from that cadaver I'm cutting up. A bit of sanding on the drivers side wheel house. I welded in the angle and the upper forward spare tire jack mounting support to the RH outer wheel well using dimensions off the parts cuda back end. We will be sanding that one down and prepping that one for primer this week as well.
