[WANTED] intake manifold Mopar 360 for 6-71 blower!

-
Status
Not open for further replies.

dodjet

retroceder nunca,rendirse jamas!!
Joined
Apr 25, 2020
Messages
16
Reaction score
2
Location
Argentina
Rating - 0%
0   0   0
Contact seller
Hi people! I'm Daniel, from Argentina, and I'm interested in trying to get a manifold to install a 6-71 blower in my Mopar with 360 motor, preferably used, since new it is difficult for me to pay for it, thank you very much in advance!
 
Email these guys . Maybe they know where a used one is . Or a new at a reasonable price .

mailto:info@theblowershop.com
 
hi mbaird!

Thank you very much for the information !! Greetings
 
hi krazykuda!

Thank you, I also verify the address you sent me!
 
thank you MiradaMegaCab!

Thank you, there I sent a message to the seller of the item you recommended, maybe it is the correct option that I am needing! Thank you again!
 
I built one from an offy 2x4. Bought an aluminum blower spacer, shored up the sides with 3/8” aluminum, had my buddy take the mill over it til it was flat. Didn’t take much off over a clean up on the front side. It’s on a b block, but same idea. That’s probably the next one I finish. Haha
 
Hola TheGrateRonzini!!
Thanks for the information, there I sent a message through the Offy manifold, I hope I can find out how much the shipment would cost to Argentina!
 
Status
Not open for further replies.
-
Back
Top