Stop in for a cup of coffee

zkx14 said
Wifemobile (09 Journey) going for inspection tomorrow, so checked brakes. Front pads were getting low, so did them. Rotors weren’t too bad, but was going to pull them off and clean the rust buildup off the edges. Couldn’t move them. So, just did quick cleanup in place.
@Tooljunkie @MOPARMITCH any tricks to getting them off besides beat the F out of them? I did hit one of them pretty good around the edge and between the studs, but didn’t want to kill it since not replacing.
Click to expand...
Water and air hammer with a large blunt face bit. In my opinion the only way. Rotors and drums dont stand a chance with me around. Reusing rotor, mark a stud and the rotor and put back in same place. small file to clean where brake pads sit in the casting. Rust builds up under the stainless “abutment” clips.

Heres a demo...