3 holes for a Swinger trunk emblem?

I saw that Dicer sent you a pic with measurements for the trunk lid emblems. Do you have the information that you need to locate the quarter panel emblems?

You are right about the straightness of pins issue, but if you try to straighten them up permanently you might just snap them off. The place that is critical is where the pins contact the emblem body. if you have to flex things to get all the pin tips in that's ok if when you GENTLY push it in it get progressively easier. I tried to install a DART sign by using the tips of the new emblem to mark the hole locations, since the pins weren't exactly straight, when I pressed it in it put more and more pressure on the little link between the A and the R and it snapped just before it was in place (((sigh))). I would suggest that if you have old pitted emblems that you snip off the posts 1/8 inch from the emblem, that way you can accurately locate the emblem on the sheetmetal and use the clipped points to mark hole locations in the old paint. If you can get the old originals to fit, my experience is that repops will slide right in.

There is a plastic version of the barrel clip that might be just a tad more forgiving. If you want a couple pitted Swinger and Dart emblems to help your project as test fits, let me know and you can have them for postage.