My Dart Swinger Project!
Small update i got some work done today I got the cable to fix the heater controls today thanks @SGBARRACUDA ! Finished up the glovebox and got the car moved around to the back yard where its level so I can get the engine put in a little easier. I also started hacking away in the driver's floor, cutting out all the rust. Im gonna do this one a little differently than the passenger side. I'm only cutting out the rusty parts and gonna patch it on smaller sections instead of the whole pan. The whole pan on the passenger side was a pita! I have to replace a small section in the crossmember im trying to figure out how im gonna do it. My plan was to weld a small plate from the inside but there is nothing there to weld too the sides are just as bad as the bottom. I think I may just cut the whole corner out and try to fab one and butt weld it in. Idk yet.
Small update i got some work done today I got the cable to fix the heater controls today thanks @SGBARRACUDA ! Finished up the glovebox and got the car moved around to the back yard where its level so I can get the engine put in a little easier. I also started hacking away in the driver's floor, cutting out all the rust. Im gonna do this one a little differently than the passenger side. I'm only cutting out the rusty parts and gonna patch it on smaller sections instead of the whole pan. The whole pan on the passenger side was a pita! I have to replace a small section in the crossmember im trying to figure out how im gonna do it. My plan was to weld a small plate from the inside but there is nothing there to weld too the sides are just as bad as the bottom. I think I may just cut the whole corner out and try to fab one and butt weld it in. Idk yet.