68' Valiant 4 door
of course it once i got the clearance for the ring i found out a casting boss on top of the TS lines up perfectly with the cross member bracing under the floor
i thought about just grinding it off but would have needed to pull the tail shaft to get up there. i can't imagine GV hasn't had anyone mention this to them. you can see from the cross member bolt hole how close it is to having enough room :mad:
well i decided to open it up from the top and make a window for it. drilled an 1 1/2" hole though the floor and then used a grinder bit to shape what i needed
a little more massaging toward the back and fits just like it was made for it...:rolleyes:
i'll be dropping off the driveshaft in the AM and hopefully getting the hole patched up tomorrow
of course it once i got the clearance for the ring i found out a casting boss on top of the TS lines up perfectly with the cross member bracing under the floor
i thought about just grinding it off but would have needed to pull the tail shaft to get up there. i can't imagine GV hasn't had anyone mention this to them. you can see from the cross member bolt hole how close it is to having enough room :mad:
well i decided to open it up from the top and make a window for it. drilled an 1 1/2" hole though the floor and then used a grinder bit to shape what i needed
a little more massaging toward the back and fits just like it was made for it...:rolleyes:
i'll be dropping off the driveshaft in the AM and hopefully getting the hole patched up tomorrow