**NEW Edelbrock Victor Series Small Block Heads**

rumblefish360 said

And what exactly is that work? Exactly....
Described below by Matts440?

Thank you!

Did t someone say earlier that there was an issue with a bolt hole or.......????

I’d like to go there (Ritter block/Victor heads) and do some stupid crazy stuff. Not just yet. The have to have it cleared in my head, then wallet.

Now I discover a oiling issue written above?

Click to expand...

Only oilong issue is you need to drill 1/2" holes in the can tunnel, maybe notch the oiling holes to line up a little better to the crank bearings, if going over 7k might open to the priority main oiling feed hole a little bigger, make sure the rear oil return hole clears the pan gasket and if you want to dipstick hole need that machined or do a side pan one like I did, and got a lokar dipstick and cut it to size for the amount of oil.