**NEW Edelbrock Victor Series Small Block Heads**

rumblefish360 said
A 1/2 hole in the cam tunnel?
Can you post a good picture of this?
Notch crank bearing oiling holes to match the bearings. These are the oil feed passages to the crank correct?
From the main feed, gotcha.
Possibly bigger for over 7K. Gotcha....

Can you post a picture of this area.

(Yes, oiling is a weak point with me.)

Thanks for helping me (and us the board) !

Here a pic of the holes I did to the cam tunnel, the oil drain back is the hole to the left of the rear main cap, nice thing is was the block only needed very little opening to match the bearing oil feeds, course it would have been better to open the bearings to match instead. Sorry don't have a pic of the oil passages opened up.