My other Early A ---65 Dart post

White 66 parts car is going under the knife. I removed the whole trunk floor except for the driver side trunk extension piece to the left of the flange. I drilled out all the welds from the floor to the frame rail easy enough but couldnt figure out how to drill the welds to separate the main floor from the extension piece on the side. Its a vertical flange underneath the car which is obstructed by the leaf springs on one side and the frame rail on the other side. I ended up just cutting it about 1/4 inch from the flange.

The passenger side was cut right along the edge where it starts to drop off. I left just a bit of the corner where it meets the wheel well since its needed to fix a bit of rust in the other car. I tried to cut the whole thing bigger than I actually needed that I way I can just trim off what I dont need once it get in laid in place.

Luckily the outer driver side extension on the other dart that its going into is in good condition because it was almost too large to remove through the trunk opening.

thumbnail (26).jpg

thumbnail (25).jpg

thumbnail (23).jpg

thumbnail (24).jpg