Old Lunati Cam Specs

I have an old(30 plus years) Lunati Hydraulic flat tappet cam that I'm trying to get all the spec's on. I called Lunati and gave them the numbers on it and they said they have no info. on it. I pulled it out of a 340 that came in a cuda I bought 20 plus years ago. It didn't have too lopey of an idle from what I remember but the rods were knocking so badly I only ran it for a couple of minutes. It's still in very good condition. I'm hoping someone here has one or has used one and remembers the specs and rpm range. I'm hoping it's a pretty mild cam because I have a 318 in an 86 D150 that has a flat lobe.(yes I read the 318 cam thread) Here's the numbers stamped onto the back of the rear journal: 110(LSA?) 3D(stamped upside down next to the 110) 285 300. That's all the numbers on the journal. There are some casting numbers between the lobes but I don't think they'll mean anything. I measured the cam lobes and came up with .305" lobe lift on both intake and exhaust which would give .458" valve lift. If I can't find all the spec's I may just send this one to Oregon cams and have them re-grind it to suit my needs.

Thanks,