65 Dart Wagon Conversion to a Sedan Delivery
I haven’t forgot my AC/heater rebuild. I removed the nuts holding everything together on the blower motor to send them off to get them cad plated. The blower assembly consists of the motor, squirrel cage, top and bottom plate with a rubber seal sandwiched between the two, nuts and 3 rubber isolators. I noticed that the squirrel cage side of the motor was gloss black from the factory so everything will get gloss black
After wire brushing the motor and two plates clean, they got a coat of etching primer
Then everything got a coat of Krylon Gloss Black
then time to reassemble it. The 2nd ring from the left is the rubber seal that’s including in the DMT early A heater/AC rebuild kit and is identical to the original seal.
And reassembled almost ready to install into the AC part of the housing. I say almost ready as I sent the nuts used to secure the blower housing to the rings to get Cad plated as they were originally - the nuts shown will be replaced with the correct replated nuts
I haven’t forgot my AC/heater rebuild. I removed the nuts holding everything together on the blower motor to send them off to get them cad plated. The blower assembly consists of the motor, squirrel cage, top and bottom plate with a rubber seal sandwiched between the two, nuts and 3 rubber isolators. I noticed that the squirrel cage side of the motor was gloss black from the factory so everything will get gloss black
After wire brushing the motor and two plates clean, they got a coat of etching primer
Then everything got a coat of Krylon Gloss Black
then time to reassemble it. The 2nd ring from the left is the rubber seal that’s including in the DMT early A heater/AC rebuild kit and is identical to the original seal.
And reassembled almost ready to install into the AC part of the housing. I say almost ready as I sent the nuts used to secure the blower housing to the rings to get Cad plated as they were originally - the nuts shown will be replaced with the correct replated nuts
