What Are You Doing To/With Your Car Today?

gtgto said
Got the trans, clutch, pressure plate, flywheel and bell housing out. Brought the trans to a friends shop to be gone through. Trans works great just leaks so I'm hoping just new bearings seals and gaskets will do the trick. So much old caked on crap on the engine and trans and since I have it this apart I'm going to do a rear main seal and new pan gasket since everything is soaked. Hoping to make it presentable with a degreasing and maybe find if there is still anything leaking. No oil was hitting the ground but its all over the place. Whoever owned the car before I did just let it leak and never addressed the issue. After I clean it all up and get the seal and HV oil pump in I can start reassembly. Got the flywheel cut today and received my new trans mount and Mccleod Street Pro clutch kit so it won't be long before I am putting her back together. Pretty productive day off today and I got one tomorrow too.

Rear main seal, HV Oil Pump, and pan gasket were done first. Pilot Bushing in place. The old one was literally worn down to about 1/3 of the correct thickness. Newly resurfaced flywheel in and torqued down. Clutch and pressure plate in and bell housing mounted. Just need to take a look at what is needed to put the z Bar back together since I have it not connected to the bell housing yet. All nicely painted and cleaned as I go along.