Project Crusty Biscuit (65 Plymouth Valiant)
Didn’t do very much during the day today. I like,to use Sunday’s to relax, do grocery shopping, and refresh for the upcoming work week. I sat around and watched YouTube for most of the afternoon. I really enjoy some of the channels that focus on fabrications anyway, at about 9PM I was caught up and didn’t have anything better to do and didn’t feel like going to bed so I thought I would putz around and work on the new floor skin for the rear floor hump. This is what I managed bending some 18Ga over some 2” solid square bar and the edge of my work bench. I unfortunately don’t have a sheet metal brake which would have made this process much easier...
I still need to cut out and make the piece for the tunnel so I’ll work on that tomorrow.
Didn’t do very much during the day today. I like,to use Sunday’s to relax, do grocery shopping, and refresh for the upcoming work week. I sat around and watched YouTube for most of the afternoon. I really enjoy some of the channels that focus on fabrications anyway, at about 9PM I was caught up and didn’t have anything better to do and didn’t feel like going to bed so I thought I would putz around and work on the new floor skin for the rear floor hump. This is what I managed bending some 18Ga over some 2” solid square bar and the edge of my work bench. I unfortunately don’t have a sheet metal brake which would have made this process much easier...
I still need to cut out and make the piece for the tunnel so I’ll work on that tomorrow.