1969 Dodge Dart Swinger clean up
PST's reinforcing plates. Looks like I have to do some trimming first to clear the sway bar mount as A bodies tabs are welded to the bottom edge, while B bodies are welded to the top edge.
ALWAYS think outside the box!! Drilling a couple of holes in the end of the cabinet.
Bit of rubber edging.
Hole saw diameter was picked based on some plugs I had.
Now I can do the sway bar one end at a time.
Lower hole will let me do one side of the bar.
Upper hole will let me do the other side.
Taking my own advise that I gave a guy the other day to drain the steering box. "Put it in front of the heater, upside down, and the grease should liquefy and drain out". Bad advise so far, not a drop. We'll see what morning brings!
PST's reinforcing plates. Looks like I have to do some trimming first to clear the sway bar mount as A bodies tabs are welded to the bottom edge, while B bodies are welded to the top edge.
ALWAYS think outside the box!! Drilling a couple of holes in the end of the cabinet.
Bit of rubber edging.
Hole saw diameter was picked based on some plugs I had.
Now I can do the sway bar one end at a time.
Lower hole will let me do one side of the bar.
Upper hole will let me do the other side.
Taking my own advise that I gave a guy the other day to drain the steering box. "Put it in front of the heater, upside down, and the grease should liquefy and drain out". Bad advise so far, not a drop. We'll see what morning brings!