6.1 Hemi 69 Barracuda Fastback Father Son Project
Happy New Year!
Got the AC Condenser where I want it and got a start on the plumbing.
First to make a hole for a 90* elbow to go through.
Test fitting with rubber lines that were included with the kit before making up the braided stainless lines that will be in the Engine Compartment.
Hard lines will run between the inner and outer fender.
Need to enlarge the hole a little bit more but need a new big step bit.
Will put a large rubber grommet in the hole after I enlarge it a little more.
O-Ring Female to O-Ring Male Elbow on the outside to a 90* down with service port inside.
Thought about a bulkhead in the core support but I'm liking how this is working out.
Next will be a flex line to a bulkhead through the inner fender.
Don't know if I could be much slower but at least it's progress.
Bending the hard lines to fit should be interesting...
Happy New Year!
Got the AC Condenser where I want it and got a start on the plumbing.
First to make a hole for a 90* elbow to go through.
Test fitting with rubber lines that were included with the kit before making up the braided stainless lines that will be in the Engine Compartment.
Hard lines will run between the inner and outer fender.
Need to enlarge the hole a little bit more but need a new big step bit.
Will put a large rubber grommet in the hole after I enlarge it a little more.
O-Ring Female to O-Ring Male Elbow on the outside to a 90* down with service port inside.
Thought about a bulkhead in the core support but I'm liking how this is working out.
Next will be a flex line to a bulkhead through the inner fender.
Don't know if I could be much slower but at least it's progress.
Bending the hard lines to fit should be interesting...