6.1 Hemi 69 Barracuda Fastback Father Son Project
Made some more holes today. I'm really liking the Hydraulic Hole Punch Driver.
First for the Heater Lines. Drill Pilot holes first.
Then punch them out.
What it looks like from the inside.
A few pumps of the handle...
And presto... we have hole!
Rinse and repeat...
We now have two Holes!
Add a pair of bulkhead fittings.
Quick test fit with some heater hose.
Not too shabby. Think that will do just fine.
The back side of the heater lines Bulkhead.
Leaving the inside heater line plumbing for later, I moved on to Coolant Line Bulkhead install.
Same process but had to flatten the little channel for the bulkhead plate. I used the Hydraulic ram with 2 flat surfaces facing each other to flatten it out. I'm liking this tool more and more. Wonder what else I can think of using it for? I got some dimple dies to use with it but no dimple plans yet... Anyway, here are the coolant bulkhead fittings installed.
continued...
Made some more holes today. I'm really liking the Hydraulic Hole Punch Driver.
First for the Heater Lines. Drill Pilot holes first.
Then punch them out.
What it looks like from the inside.
A few pumps of the handle...
And presto... we have hole!
Rinse and repeat...
We now have two Holes!
Add a pair of bulkhead fittings.
Quick test fit with some heater hose.
Not too shabby. Think that will do just fine.
The back side of the heater lines Bulkhead.
Leaving the inside heater line plumbing for later, I moved on to Coolant Line Bulkhead install.
Same process but had to flatten the little channel for the bulkhead plate. I used the Hydraulic ram with 2 flat surfaces facing each other to flatten it out. I'm liking this tool more and more. Wonder what else I can think of using it for? I got some dimple dies to use with it but no dimple plans yet... Anyway, here are the coolant bulkhead fittings installed.
continued...