6.1 Hemi 69 Barracuda Fastback Father Son Project
Another view
Inside
Heater fitting circled in yellow and the AC fittings in red.
Next up... bend these to fit as needed.
Should be interesting. The -10 will not need much bending but the -6 line will be going all the way forward and around the corner in front of the core support to the Dryer.
Will start it at the dryer being sure to put enough bends to make a nice fit.
The -10 line will stop short of the core support and connect to a 90* bulkhead fitting.
The 90* fitting can go right where the -10 line ends...
That's all for now.
Back to the day job tomorrow... Not as fun but the pay is a lot better!
----o00o--'(_)'--o00o----
Another view
Inside
Heater fitting circled in yellow and the AC fittings in red.
Next up... bend these to fit as needed.
Should be interesting. The -10 will not need much bending but the -6 line will be going all the way forward and around the corner in front of the core support to the Dryer.
Will start it at the dryer being sure to put enough bends to make a nice fit.
The -10 line will stop short of the core support and connect to a 90* bulkhead fitting.
The 90* fitting can go right where the -10 line ends...
That's all for now.
Back to the day job tomorrow... Not as fun but the pay is a lot better!
----o00o--'(_)'--o00o----