[Found!] 7.550” push rods

-
Status
Not open for further replies.
I’ll check them out I called smith brothers and they quoted me $200 that’s a bit out of range for this engine.


They made a set for my buddy Eddie when we built his 340... They were around $80 for a full set...

Some of the wrong ones that were off the shelf were sometimes $10 each or $160 a full set...

OE custom made them cheaper and had them to us in 3 days... (before covid delays were a thing)
 
Got them, I had a set close by & just remembered. PM me your email address & I'll send pictures.
 
Whats the application ? Spring rate ? Lift ? Stock Rockers ? Solid or Hyd cam ?
 
I just changed pushrods to oil thru.
I pulled out a set of Smith Bros hardened 7.55/7.60 pushrods that had maybe 1 hr on them . But these are ball to cup .
 
360 small hydraulic cam xe256 with 901 springs nothing fancy 353lb spring rate basically stock the original solid push rods are leaving me with 0 preload I want to set preload at .050” or about.
 
Status
Not open for further replies.
-
Back
Top