trim finishing hammer

Eastwood has some trim hammers. Never seem much in HF. Typically you need some sort of smaller tool to position exactly on the area then hit that with a hammer.

you can look at a cheap HF punch set and grind the ends smooth. An old thick flat head screwdriver with the end bull nosed ground smooth works too.

I use a radiator hose picker at lot. It’s ok to bang the plastic end since you don’t need to hit it hard to move aluminum. It gets in tight places.

Better https://www.amazon.com/dp/B07G4GPY5B/?tag=fabo03-20

ok: Pick and Hook Set, 7 Pc.

For small dings I’ve used a HF automatic punch with the end bull nosed off smooth. Works good on aluminum. It will leave a little ding going out in the outside. Then you file or send that flat. Automatic Center Punch with Brass Handle

Pot metal, I’ve never straightened dents. That stuff doesn’t move around like stamped sheet stainless, iron, or aluminum