1969 Dodge Dart Swinger clean up
Trailer on ready to go in the morning and at least I got my wiring clips made...
Pattern for new wiring clips.
Part of an old tool box is just a bit thicker than stock but will work nice.
Stacked them up and drilled for the bending slot. DON'T DO THIS...
Holes too close to edge.. we'll start again!
New set sheared out and drilled one at a time, then slotted between the holes.
Tabs bent and shaped.
The first one came out nice.
I bent the rest backwards by unintentionally flipping the part and following the slot slant. Oh well.. the 2 on the side will be backwards, nose will get the correct one.
My plasti dip is still good! Had it for years, sealed with tin foil.
Dipped and letting them dry, welding will happen another day. Tomorrow is shot going to get my new lift!!! :D