Annoyance is right! I’m going through this on my 360 build. now when you say ‘killed’, what do you mean by this? @yellow rose on a milled intake, would I use thinker gaskets to make it work on another engine?
Auto correct/lack of proof reading, instead of “Killed” it should read “Milled.”
Your question to YR is yes, depending, there are factors of how much the intake has been milled and how much the deck was milled and how much the cylinder head has been milled. It is possible that a thicker gasket will not have to be used. The aluminum also bends a lot, so a most minor gap can be OK. Ideally, you want the intake to sit, without help, you n the cylinder head perfectly aligned ready to be bolted down, ports aligned.
