My Duster Adventures
Progress report for today.
First thing I did on the car today was roll it outside (again) and washed out the front wheel wells, engine bay and the floor pans with the pressure washer. The floor pans STILL aren’t very clean, but good enough for now. Next I rolled the car back inside, mocked up the upper coil over hoops, drilled the needed holes, then disassembled everything again. I then sprayed down the front wheel wells with brake cleaner and gave them the ole rattle can restoration.
Forgot to take a before picture but here’s after I painted the wheel wells.
I then installed the upper hoops/coilover mounts for good.
Next I started wire wheeling the floor pans. I’m gonna have to change the passenger rear pan and also have a small section on the passenger front to patch as well as holes where a previous owner drilled for bucket seats. Hopefully more progress to come tomorrow!
Progress report for today.
First thing I did on the car today was roll it outside (again) and washed out the front wheel wells, engine bay and the floor pans with the pressure washer. The floor pans STILL aren’t very clean, but good enough for now. Next I rolled the car back inside, mocked up the upper coil over hoops, drilled the needed holes, then disassembled everything again. I then sprayed down the front wheel wells with brake cleaner and gave them the ole rattle can restoration.
Forgot to take a before picture but here’s after I painted the wheel wells.
I then installed the upper hoops/coilover mounts for good.
Next I started wire wheeling the floor pans. I’m gonna have to change the passenger rear pan and also have a small section on the passenger front to patch as well as holes where a previous owner drilled for bucket seats. Hopefully more progress to come tomorrow!