65 dart rear windshield
OK looks like it's a rope in type from what I see. Put the rubber on the glass get a nylon rope no bigger than 1/4" and no smaller than 13/64" and insert it around the rubber that goes in the metal pinch weld that holds the rubber and glass to the window metal frame and have the ends of the rope overlap at the middle bottom of the rubber. Gonna need to people to do this the first time. center the glass to the pinch weld with the rubber gasket on the glass and the guy on the out side of the car holding the glass and a slight pushing in to keep it tight against the car.
Have a guy on the inside of the car pulling the rope to make the edge of the rubber go over the pinch weld. Once the bottom and around both lower corners are over the pinch weld try and push the glass straight down to seat it and then pull the rope so the rubber goes around the pinch weld on both sides evenly.
Top corners are the hardest and be careful pulling on the rope that you don't cut the rubber.
Not good at explaining things but have done hundreds of rubber set windows.
