A-833 Input Shaft Help!

AJ/FormS said

Hah, you guys put too much faith in me; I have never measured those.
But I can tell you anther thing; I have never had to struggle to put those in!
Those rollers do so little work, I would not be afraid to reuse the old ones. The ones in mine are probably circa 1969.

Click to expand...

Yeah but you've put a lot of these together and never run into this so what is different here?
Rollers are probably ok unless Jamie got some out of spec parts.
ID of input shaft?
I would not mix old with new as larger ones would be taking the load and smaller ones would not be doing anything except acting as spacers. I looked at my old ones and there really is no discernible difference when compared to my new Passon parts. AJ says use the old ones so that may be where you are going.

*****
I'm old enough to remember Eric Vonzipper. When did you get off motor sickles and into cars?